how to open Technics headphones, no screws apparently |
  |
how to open Technics headphones, no screws apparently |
 Jun 3 2012, 06:11
Post
#1
|
|
|
Group: Members Posts: 69 Joined: 7-January 06 Member No.: 26940  |
After 6 years of flawless operation I need to open the headphones since a problem with lead has occured in the joint (?). The headphones are Technics RP-F350. Is anybody familiar how to open such headphones please? There are no screws inside and nothing can be stripped off. The only idea I have is to take out that "mount" somehow from the holes and then it might possibly fall apart... I am asking if there is somebody who have done this before...
|
 |
 
|
|
Jun 3 2012, 20:21
Post
#2
|
|
|
Group: Members Posts: 69 Joined: 7-January 06 Member No.: 26940 |
OK. I have managed to open them.
1. I had to strip down the black pads which are held with a rubber. 2. Then I had to take out the handle and be careful since there is a wire on one side. 3. Then I had to unclip the transparent part. 4. Finally I had to rotate slightly the black base against the golden cover anticlockwise. There are "rails" that lock them together. Perhaps, steps 2 + 3 are not necessary but at least I have all the parts taken apart to clean them properly... correction: steps 2 + 3 are necessary because that transparent part locks the rotation. This post has been edited by maiki: Jun 3 2012, 20:38 |
|
|
|
|
|
Lo-Fi Version | Time is now: 25th May 2013 - 16:43 |
