Welcome Guest ( Log In | Register )

Reply to this topicStart new topic
Converting joint stereo to mono
post Oct 29 2013, 11:19
Post #1

Group: Members
Posts: 1
Joined: 29-October 13
Member No.: 111281

I hope this question is not too basic for this forum.
If I am converting a 64 kbit/s CBR joint stereo mp3 file to mono (using dBpoweramp), what bitrate should I use to maximise quality but prevent up-sampling?
Go to the top of the page
+Quote Post
post Oct 29 2013, 13:22
Post #2

Group: Members
Posts: 3309
Joined: 1-September 05
From: SE Pennsylvania
Member No.: 24233

What do you mean by up-sampling?

If the original material is nearly mono already then the quality of the 64 kbit joint stereo is essentially the same as it would have been in 64 kbit mono.

If, on the other hand, there was considerable stereo separation then that would have taken up some of the bits and the quality would be somewhat less than a 64 kbit mono version.

If you transcode from mp3 to mp3 then there will be some loss in quality, so you should reencode to a higher bitrate to minimize the loss. It has been reported that as far as lossy to lossy transcoding, mp3 to mp3 is among the worst for loss in quality.
Go to the top of the page
+Quote Post

Reply to this topicStart new topic
1 User(s) are reading this topic (1 Guests and 0 Anonymous Users)
0 Members:


RSS Lo-Fi Version Time is now: 23rd April 2014 - 11:11