Hydrogenaudio Forums > convert stereo to 6 outputs

lenainrouge

Oct 27 2005, 14:26

Hi,

I've recently buy a fantastic sound card. it sounds... damm, very very good.
M-audio delta 1010 has 8 hardware outputs:
8 x 8 analog I/O on balanced/unbalanced 1/4” TRS
so, exactly, you need 2 outputs for a stereo sound.

http://www.m-audio.com/products/en_us/Delta1010-focus.html

I would use more than 4 outputs (thanks to plugin convert stereo to 4 chanels). I have searching something but the only plugin that i've found is chanel_mixer wich don't give the same sound on 6 outputs. Is there something for using 6 or more chanels ?

BloKosss

Oct 27 2005, 16:13

QUOTE(lenainrouge @ Oct 27 2005, 09:26 PM)

Hi,

I've recently buy a fantastic sound card. it sounds... damm, very very good.
M-audio delta 1010 has 8 hardware outputs:
8 x 8 analog I/O on balanced/unbalanced 1/4” TRS
so, exactly, you need 2 outputs for a stereo sound.

http://www.m-audio.com/products/en_us/Delta1010-focus.html

I would use more than 4 outputs (thanks to plugin convert stereo to 4 chanels). I have searching something but the only plugin that i've found is chanel_mixer wich don't give the same sound on 6 outputs. Is there something for using 6 or more chanels ?

Hi, the trick would be to use an active filter which can output 4 stereo channels (-> 8 mono outputs if my calculator didn't make any mistake) with low pass @ >20khz for each way. It's tinkering but it works.
http://www.hydrogenaudio.org/forums/index....showtopic=29316

lenainrouge

Nov 1 2005, 07:07

Thanks you very much BloKosss. For months i was searching for a solution like this one. You saved my patience. Thanks you !